Settings for MGL ROTOR-1

funnyb0nz

Newbie
Does anyone happen to know the settings in order to set up the Rotor Tac for the MGL Rotor-1? I have Aircommand with 108 teeth, got the sensor hooked up and just trying to figure out the settings. 100% value is currently set at 1000
Pulse/Rev is at 1.0
Filter is set to Span
Pulse is set for pulse

Thanks in advance!
 
If your sensor counts actual Gear Teeth...

100% value: 350 (Or whatever your Rotor Cruising rpm is)
Pulse/Rev: 108 (Number of Gear Teeth per rev)
Filter: Scale
Pulse: Pulse


If your sensor counts Magnets...

100% value: 350 (Or whatever your Rotor Cruising rpm is)
Pulse/Rev: 1.0 (Or the number of Magnets per rev)
Filter: Scale
Pulse: Time


This is all explained in the Owner's Manual.

http://www.mglavionics.co.za/Infinitec/Manuals/Rotor1.pdf
 

funnyb0nz

Newbie
Thanks, I actually called MGL up and they helped me out. Now the 100% value I just left what ever was in there. I am not sure what the rotor crusing RPM is. But everything else is the same for Filter and Pulse.
 
Top