Rowdy
Newbie
Hi,
I recently purchased a Bensen style, single place gyro that came with a set of 23 foot McCutchen blades.
I was looking for Jim McCutchen's current email address so I could contact him regarding the correct procedure for setting up the teeter block on the hub bar.
I tried [email protected] but never recieved a reply.
Does anyone have Jims current email address or the procedure for setting up the teeter block?
Thanks.
Regards Rowdy
I recently purchased a Bensen style, single place gyro that came with a set of 23 foot McCutchen blades.
I was looking for Jim McCutchen's current email address so I could contact him regarding the correct procedure for setting up the teeter block on the hub bar.
I tried [email protected] but never recieved a reply.
Does anyone have Jims current email address or the procedure for setting up the teeter block?
Thanks.
Regards Rowdy