Recent content by Bartek

  1. B

    Blades balancing

    It is from Iveco car. This is the driveshaft of the front wheel.
  2. B

    Blades balancing

    Thanks a lot. Now I have full information about this process. One question about blade holder. I have 5 holes in it 8mm each. In instruction you send me there is 10mm. Should I calibrate it to 10mm?
  3. B

    Blades balancing

    Thanks a lot. I have blade holder the same as you ad closing plates. I only don't have this element witch is inside the blade but i think it is easy to make it myself.
  4. B

    Blades balancing

    Thank you very much for your advice. I will definitely use it. My profile is slightly different than the one you uploaded in the photo. Do you think that in my case it is necessary to use rectangular profile to effective clamping of the blade?
  5. B

    Blades balancing

    You mean how the propeller is powered? I haven't started it yet, but I used the same propeller drive in paraplane and it worked well.
  6. B

    Blades balancing

    Hello everyone, I am new to this forum. I'm building my own gyroplane and I'm doing fine, I'm almost done. There is still electrical installation to do, but this is make by a specialist, my colleague. However, I have a problem with the rotor blades, namely with their balancing. I bought the raw...
Top