Announcement

Collapse
No announcement yet.

Control Joystick Assembly

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • #16
    Erik, did you buy a Warp Drive ? What engine will you be using ?
    Happy Flying, Chris S.

    Comment


    • #17
      No, so far Scott Essex has my wooden Arrow Prop. I'll use my old, never run Rotax 503 SCSI. I have most of the the needed parts, that needs exchanging after 30 years on the shelf. It also has the old wrist pin bearing. Today I just received two used carbs off an 582 - so now I can get the last 5 HP from the 503, if I should need them.
      In two weeks I'll get my new car and then drive to Stockholm (Sweden) to buy the needed 6061-T6 aluminum. Then I'll get cracking in my workshop. First I'll get the 503 ready and then I'll install Digital Read Out on my mill, so I can place some precise holes.
      Cheers
      Erik

      Comment


      • #18
        Now I have my new car and I just bought the ferry ticket to Sweden. Target is "Arigo", just north of Stockholm.

        They have all I need in terms of aluminum and some other stuff as well. But it's an expensive trip, so I'd rather not do it twice.

        What raw material will I need to build a walking beam joystick?

        Cheers
        Erik

        Comment

        Working...
        X