Ej22 ecu and wiring harness needed

[richardkennedy]

Does anyone know of an EJ22 ECU and wiring harness that is available. This is for a fuel injected motor. I would consider trading a Rotor Hawk tall tail and horizontal stab for a good set or purchasing outright. If you know of one or think you know of one that might be available please call Richard Kennedy at 501-514-4842.

[WHY]

Hi Richard

Have you tried any of the area foreign auto salvage yards, Joplin has 2 nice sized ones, John meyers auto salvage and 66 truck and foreign salvage

Tony

[GregBradley]

I have both for sale. requires no O2 sensor. bought from rewiring company that supplies for sand rails. Also have a Autoflite redrive with 10 minutes on it. Make me an offer!

[cbonnerup]

Greg,
What ver. of the Autoflight and what ratio? Also, to prevent embarrassing questions, what approximately are you hoping for the gearbox?

Chris

[GregBradley]

Hi Chris,

the ratio is 2.2/1 Neil in New Zealand says it's the best ratio and Jim with GyroBee 2 likes that ratio with his Ecotec engine.

I bought it new and with shipping from New Zealand was 2917.00 USD. They aren't cheap but are a great insurance policy! I have an Ecotec engine now so I don't need it, but I need to buy a new one, once again. Make me an offer. Greg 816-479-5229.

[GregBradley]

In regards to the ECU and wiring harness, I have for sale the Stinger style ECU and pre-wired harness. See this link.. http://www.outfrontmotorsports.com/wiring_harness.htm

It was originally $1450.00. I have since purchased a wiring harness for my GM Ecotec engine. So I would like to move this harness too. Make me an offer please!