Balancing Bensen Blades - Rotary Wing Forum

11-14-2004, 08:59 PM

GitItOn

Member

Join Date: Nov 2004

Location: Medford

Posts: 15

Balancing Bensen Blades

I was told to screw a hole in the tip of the rotor and thread a small screw in to balance (adding washers if/as needed). My blades are near perfectly balanced, but I thought I'd check. vibration is minimal, but there....
Bensen 10' Blades with a 4' hub bar
http://www.physicalflight.com/pictur.../dscn3360.html

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Review: Raf Blades	automan1223	Rotor Blades	1	10-21-2004 03:54 PM
Bensen, Subaru, Trailer & Blades	GyroRon	For Sale	25	09-16-2004 05:16 PM
Original Bensen Blades Good to use or ?	FlyingFish	Rotor Blades	7	05-07-2004 04:53 AM
Balancing Blades/oftentimes futile	KenSandyEggo	Rotor Blades	4	04-26-2004 04:42 PM
2-per-rev shake	Jim	Theory of Flight (Aerodynamics)	29	04-21-2004 01:44 PM

All times are GMT -8. The time now is 06:04 AM.