|
|
#1
08-22-2004, 11:57 AM
|
|||
|
|||
Internet Machine Shop!
I found an article in this morning Houston Chronicle about an Internet machine shop that I thought some of you would also find interesting and may even have a use for.
The Chronicle has been doing some crazy things lately and may require you to register in order to read this. If you run into that problem and can't read it then I'll post the details here. http://www.chron.com/cs/CDA/ssistory...siness/2750130
__________________
Dean Dolph PRA (dues paying!) Life Member# 8907 EAA# 657196 Why Dean doesn't fly! http://www.rotaryforum.com/forum/sho...20439#poststop Everything should be made as simple as possible but not simpler! - Albert Einstein Everything in moderation including moderation - Mark Twain There's is no future in growing old - Me! 
|
|
#2
08-22-2004, 12:26 PM
|
||||
|
||||
|
I've used their software before and it's quite easy. It's no AutoCad or SolidWorks, but does a pretty good job for the modest requirements of most machined parts. It's a great concept, and I hope it catches on.
__________________
When someone annoys you, it takes 42 muscles to frown, but it only takes 4 muscles to extend your arm and whack them in the head.
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| A Dream Machine | PTKay | Two Place Enclosed Machines | 135 | 09-29-2006 08:41 AM |
| Machine shop fired!.....and poll | KenSandyEggo | Rotor Blades | 47 | 09-21-2004 12:06 PM |
| What parts can I make using 3/16ths 6061T6?? Have access to machine shop... | KDOG | Gyrobee and Related Designs | 3 | 09-18-2004 05:02 AM |
| shop progress from the air | StanFoster | Flying Photos | 3 | 09-05-2004 06:53 AM |
| Another training success story | Aussie_Paul | Training | 11 | 08-09-2004 12:33 PM |
Linear Mode
