|
|
#1
06-19-2004, 01:56 PM
|
||||
|
||||
Gyrobee Engine Mounts
Hi Folks,
What rubber mounts do people recommend for a Rotax 503 in a Gyrobee. The Barry motor mounts (CPS PN 3003, 3005, 3007) look like the right thing. They come in three different hardness’. If these are the correct mounts, have people found any particular hardness to work best? Thanks & Regards, Gene 
|
|
#3
06-21-2004, 03:40 AM
|
||||
|
||||
|
Snubbing Washers
Thanks John.
Hi Folks, Forget what I had previously posted here about Snubbing Washers. Aircraft Spruce carries them. Thanks & Regards, Gene Last edited by GeneWeber; 06-21-2004 at 06:58 AM.
|
|
#4
06-21-2004, 06:59 AM
|
||||
|
||||
|
Gene: If you really want the "official" Barry-supplied snubbing washers, a Barry dealer can get them for you. They're about 2 bucks apiece and the dealers sound sheepish when you even ask about them.
Standard AN 970 fender washers work fine.
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| First rotary engine developed for aviation | rfonseca | Engines | 9 | 01-29-2005 11:48 AM |
| Why not use real aircraft engines on LW's? | GyroRon | Tractor Designs | 73 | 11-11-2004 07:49 PM |
| Gyrobee Engine for sale - Cheap!!! | GyroRon | For Sale | 4 | 11-09-2004 03:46 PM |
| Subaru Engine tuning 101 | automan1223 | Engines | 7 | 09-22-2004 07:33 PM |
| Engine Rebuilders | cgmg | General Discussion | 10 | 08-14-2004 05:34 PM |
Linear Mode
