Need help with my mac 90hp

I'm in the process of rebuilding my 90 hp mac for my gyro,
my connecting rods have 24 pin bearings with no cage on the large end, I cleaned all the pins, and have noticed 25 of them should be replaced,
I am not shure how to identify the rod " a " or " e" . Mine have AE casted into them. Or what type of bearing is in it. Was wondering if this is a mod, or factory? And how do I identify my rods? I think the pins are 0.186 X 0.912,
my caliper is not calabrated so I might be oit a couple 0.000
I was going to order my parts from R&D but need to know what I have. also the rod has F-05418 casted into it.
thanks for the replies

pics down 5 posts

You need to call Rick Whittridge!
937-878-2598

thanks Dave

Please do not call as I will not be answering questions. I am retiring from the Mac! If you guys need questions answered call R&D in Texas.

It would be helpful if you could post a pic of what you have

Here are some pics

Here are some pics

Pictures of my con rod and bearings "atachments"
thanks for the replies

Those look like E rods.

It looks like you need new bearings

I called red and did some more serching, they are e rods with the locating washer shims on the piston pin, and bearings are a mod, standard rollers with no cage, thanks for the help