|
|
#76
08-15-2012, 01:51 PM
|
||||
|
||||
Have you tried looking at McMaster Carr http://www.mcmaster.com/# They seem to have a good selection of U joints
Marc 
|
|
#77
08-15-2012, 02:26 PM
|
|||
|
|||
|
Hi Marc
Went to their website, looks like one way or the other they will have what I need. May have to do some expensive experimenting, but have already started that  (good site for all sorts of things) Tony
|
|
#78
08-15-2012, 03:03 PM
|
||||
|
||||
|
If the joint is only three eights inch across, could you have the starter manufacturer broach an adapter to fit the motor and a three eights counterbore on the end. Cut the u joint to fit into the counterbore and weld the seam?
|
|
#80
08-15-2012, 06:15 PM
|
|||
|
|||
|
Jeff
The "cross bone" is 3/8 inch across, the U joint body is 3/4 inch in Dia. with a basic 3/8 inch smooth bore, and this gives me an idea, more later. McMaster & Carr may have better deals on the U joints though Tony
|
|
#81
11-18-2012, 02:54 AM
|
||||
|
||||
|
What up dates do you have?
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Linear Mode
