KB3 Pre-Rotator Plate

[Mike484]

I have the Ken Brock pre-rotator and need the 6" plate for the Rotax 582. Does anyone have one available?

[gyrojake]

I could spin ya one out for $75.00 plus shipping.

[Mike484]

I will be putting a 582 on it with a three bade warp drive, you got the bolt pattern?
Ernie told me it is 6" in diameter and 1/4" thick aluminum. If you can do it I'll certainly take you up on it.
I'll measure it in the morning to make sure.

[gyrojake]

Got it all just let me know the dia.

[Mike484]

Jake, I don't have your contact information, please send me an email at mike484@aol.com.
I measured it today, 6" diameter will not clear, when Ernie said 6" plate apparantly he meant radius, not diameter.

[gyrojake]

Here are some photos of a stock Brock. Unless you have a different set up you will only need a 9' disc. Lets have some pics of what you have.

[Mike484]

I'll be at the hangar today and will look at it again, what you have look exactly like what I have.

[Mike484]

Checked it again today, your right, it is 9".