|
|
#1
08-21-2012, 12:35 PM
|
||||
|
||||
Bensen hub bar question
I hope one of you out there can give me a little info. I have a set of Bensen/Brock blades and hub bar on my gyro. I wanted to change the bolts on the hub bar and blades and the bolts that hold the two together. I ordered standard AN 3/8th bolts but when I went to change them, I realized some of the bolts that are installed are NAS Close Tolerance bolts. Is there a requirement for these? Also I would like to replace the main teeter bolt, it is a standard AN bolt also, is that the correct bolt? I have looked through the gyrobee plans and online but I can not come up with which bolt types are correct.
Thanks, Peter 
|
|
#2
08-21-2012, 10:15 PM
|
||||
|
||||
|
Short answer...
AN 6-24 (3/8-24 x 1-15/16 GRIP, Bolt Hex) Rotor to Hub Attachments. Be careful with washers. It should be the MS20002-6, 3/8x11/16, flat SPECIAL HIGH STRENGTH (red Edges) Its the ones recommended by Bensen factory
__________________
Giorgos Cyprus http://www.aviomania.com/ Visit Aviomania Aircraft Webpage [url]http://www.youtube.com/watch?v=6QRZb- Last edited by scandtours; 08-21-2012 at 10:20 PM.
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Linear Mode
