|
|
|
|
#1
03-04-2009, 08:06 PM
|
||||
|
||||
"high-strength" washers for Bensen blades?
I was told that Bensen originally used special high-strength washers for the 8 3/8ths bolts that hold the blades on to the hub bar. I was told that originally these were red in color. Does anyone have any info on this? Is it necessary, and if so, where I might be able to find these special washers? I'm replacing my blade hardware because I lost the originals, and I want to make sure I'm getting the right stuff.
__________________
Adam Helwich President Greater Midwest Rotorcraft Club PRA Chapter 18 www.gyroclub.com 
|
|
#2
03-04-2009, 08:58 PM
|
||||
|
||||
|
You were told correct, Adams
Bensen part no. MS20002-6 3/8x11/16 washer, flat, special high strength (red edges) Giorgos
__________________
Giorgos Cyprus http://www.aviomania.com/ Visit Aviomania Aircraft Webpage [url]http://www.youtube.com/watch?v=6QRZb-
|
|
#3
03-05-2009, 11:03 AM
|
||||
|
||||
|
Thank you very much for the part number! Found them here:
http://www.bonaero.com/Washers.htm $0.10 a piece - not bad at all!
__________________
Adam Helwich President Greater Midwest Rotorcraft Club PRA Chapter 18 www.gyroclub.com
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Hybrid Mode
