StanFoster
Active Member
- Joined
- Nov 16, 2003
- Messages
- 17,139
- Location
- Paxton, Il
- Aircraft
- Helicycle N360SF
- Total Flight Time
- 1250
I hooked up the first of many connections here in the photos. I have to be careful keeping everything neat and orderly..and bundled correctly so the lower panel will tilt back easily for access.
I am using heat shrink on each terminal....not for insulating reasons..but for a better strain relief. That wire felt more secure after I hit the heat shrink with a torch. I have a bunch of mini loops to fabricate and hookup between the circuit breakers. I am going to get the right length figured out, then clone a bunch of these. They will all be bent the same and should make for a fun time wiring this lower panel.
Stan
I am using heat shrink on each terminal....not for insulating reasons..but for a better strain relief. That wire felt more secure after I hit the heat shrink with a torch. I have a bunch of mini loops to fabricate and hookup between the circuit breakers. I am going to get the right length figured out, then clone a bunch of these. They will all be bent the same and should make for a fun time wiring this lower panel.
Stan