danmcgee

hi !
i'm new in this sport
and want to build 1 seat gyrocopter (1st for cheep after that one will see)

so can u send me bluprints and part list for kb-2/3 ?
big thanks

Dan,
I would like to know what it would cost for a piece of aluminum thick enough to be a HS that would be 1ftx3ft. The stab I have on my Bensen including paint is.110 inches thick and I want to add another stab on the top of my Ken Brock Rudder inline with the prop.

The last I heard he said he'd have the stuff at Bensen Days. I was ready to send him the money for the prop but he never replied back to me. I'm going anyway. I hope I bring back a prop with me. Send Ron your money and have him take the blades back to his home and you can get them from him. A lot shorter trip than FL. I'd trust Ron's judgement to inspect the blades.

I actually got my motor from ebaymotorguy on ebay, might be the same guy. Definitely gonna post on the forum, as soon as i send this. You've been a great help and i really appreciate everything. Thanks, Tim

Thanks a lot for the plans! I have been cutting aluminum all night. I had the stuff just laying here begging me to find some plans. Have you got anymore information on the KB2 that I would find useful? Or even some parts laying around? Also, I'm using an older Rotax 503 w/o provisions for a gearbox. I can't find a belt drive system anywhere. I really hate to go get a custom job done at a machine shop, it will definitely be costly. Any suggestions? Thanks!
Tim

trl0219@yahoo.com. Thanks a lot! Tim

Hi, Dirtydog said to ask you about some plans for a KB2. I me the only guy in my area with a gyro and he is going to help me with my build. He has a KB2. I saw his, took some measurements, and ran out and bought my aluminum. Of course, now i cant find the plans. I would really appreciate any help. Thanks, Tim

Yes. A Sport Copter Vortex. It's an unfinished project. I didn't have a chance to work on it over the holidays but hoping to get back on it asap. I'll have something to show at Bensen Days. Hope to be flying this summer. The only snag will be I may have to relocate this year to keep my job.

Yeah Dan!

The problem is I'm not sure which direction I'm going to go with it yet.
Hopefully some time looking at other's machines up close , at ROC, will help me decide.



Thanks,

Bruce

I need some help in finding some Pictures of McCullough 90 PROP. I have a co, named CloudCars.com who will build me an experimental flex Prop for the 90 hp. The measurement for the Prop is # 52" x 26 p. I need a measurement of the whith of the TIP of the prop and a measurement 6 1/2" from the tip inward towards center= I need a whith measurement there. Could U put the word out and help me get those measurements? Thank, all and keep the nose up.