Rotorhead
04-29-2005, 01:07 PM
We had this discussion sometime ago on Norms forum, and couldn’t always
keep up with the discussion so I’m trying again.
Using 4130 for control rods, I weld this set up trying to keep the craft an
Ultralight. I used ¾ X .035 for the body and 7/8 X .058 and threaded
Tube Adapters from Chassis Shop any comments http://chassisshop.com/
I have an engineering student running some numbers on it, but haven’t heard back yet
keep up with the discussion so I’m trying again.
Using 4130 for control rods, I weld this set up trying to keep the craft an
Ultralight. I used ¾ X .035 for the body and 7/8 X .058 and threaded
Tube Adapters from Chassis Shop any comments http://chassisshop.com/
I have an engineering student running some numbers on it, but haven’t heard back yet