Wanted

[fun-flyer]

Hey group, we (Chapter 62 in Texas) are looking for a belted reduction drive to go on a Subaru Legacy 2.2 liter engine. Preferably a Parham (?) or similiar. It needs to be a belt drive to work with the prop that was purchased. A while back a fellow had Parham (?) for sale and I lost his info. :confused:

Also does anyone know of someone who can wire the engine to the computer to make it run or provide the needed schematics. If I remember there was a company called Eggenfelner somewhere on the east coast who did this type of work but again. I've no information. :rolleyes:

Thanks for all the advise.
Greg Massey
PRA Chapter 62
Houston Texas

[JSC]

Hi, I have a Parham redrive and wiring harness on a 2.2 rebuilt with all new gaskets, bearings and rings. The heads were done by a local shop. The engine was in very good shape when pulled apart but had it gone thru anyway. Its on a Falcon 2 place airframe with wheels and still needs finishing mast, cheek plates, rotor and prop. Has full enclosed 2 place body now with dual pedals but can go back to a single place. I would take a cash offer on the whole thing if I got some of my money back out of it.
Jeff Christie

[fun-flyer]

Hello Jeff,
We are only looking for a belted re-duction drive similiar to the one you have or an actual Parham drive. We also need a wiring harness. I'm sure your not interested in parting out the gyro. But if you are let me know. Thanks for the reply adn good luck with your sale.
Greg

[gyroplanes]

Hi, I have a Parham redrive and wiring harness on a 2.2 rebuilt with all new gaskets, bearings and rings. The heads were done by a local shop. The engine was in very good shape when pulled apart but had it gone thru anyway. Its on a Falcon 2 place airframe with wheels and still needs finishing mast, cheek plates, rotor and prop. Has full enclosed 2 place body now with dual pedals but can go back to a single place. I would take a cash offer on the whole thing if I got some of my money back out of it.
Jeff Christie
How much do you need to get out of it?