Seat tank

[joeheli]

I just finish changing all the fitting from my seat tank . Shut I use epoxy
to seal the new fittings to the seat tank to prevent leeks? and if yes Which shud I use ? :confused:

[joeheli]

Can somebody help me with this?

[KenSandyEggo]

Joe, I don't have the name in front of me, but there is one used for plastic, boat gas tanks that I've used that works well. It's a white paste and you mix in a little liquid that comes with the kit. Any boat shop should have it. If you want the name, I can get it tomorrow, or maybe someone else recalls the name. I've always had good luck with J-B Weld also.

[rehler]

Hard to answer the question without knowing what type of fittings you are using (brass screw in type, aluminum with rubber grommets, etc.) and what seat tank material (Ken Brock type, fiberglass, etc.).

For a Brock tank the best type to use is the aluminum fittings with the rubber grommets as sold by CPS. They don't leak and are easy to install and don't need any epoxy or anything else.

[joeheli]

Thank you guys for your help!