Udi
06-25-2004, 05:09 PM
This question is for people experienced with an earlier model Air Command or who have an original (~1990) Air Command assembly manual.
What kind of washer is installed between the spindle bolt head and the spindle bolt bearing? I have two washers - one 0.20" thick and one 0.26" thick. I think the correct one is the 0.20", but I want to make sure it's not too thin for the load. Both washers are aluminum. I think that the "second" washer is the one that came with the Wonderlich pre rotator and is installed between the bottom bearing busing and the torque tube.
When I install the thicker washer under the bolt head, the rotor hub bar is touching the bolt head.
Thanks
Udi
What kind of washer is installed between the spindle bolt head and the spindle bolt bearing? I have two washers - one 0.20" thick and one 0.26" thick. I think the correct one is the 0.20", but I want to make sure it's not too thin for the load. Both washers are aluminum. I think that the "second" washer is the one that came with the Wonderlich pre rotator and is installed between the bottom bearing busing and the torque tube.
When I install the thicker washer under the bolt head, the rotor hub bar is touching the bolt head.
Thanks
Udi