Balance Prop

[Udi]

Can someone give me advise on how to balance my Warp Drive prop? I think I am getting too much vibrations.

Thanks

Udi

[Aussie_Paul]

Udi, check the pich of all blades first by placing an approx 3' straight edge from the back of the blade to the floor and make a chalk mark. Do this with each blade in the same position without moving the machine.

I have a prop balancing gadget that I use for multi blade props so I will take a pic and post it hopefully tomorrow. The old pic is a millin words when you a slow typist like me!!!! Aussie Paul.

[Udi]

Thanks, Paul. My prop's blades are pitched about 11.5 dgrees. I checked with a Smart Tool. There is a difference of about 0.2 degrees between them, can that be meaningful?

Udi