Prop Hub Bolt

[eaglecarob]

OOPS - - I bunged the bolt.
The Center Hub bolt to the Mac 72hp 0100 threads are mashed. I'm embarrassed. :( Now what?
How can I fix it? Where can I get a new (or good condition used) bolt? :wacko:
The threads in the end of the engine shaft are just fine. Only the bolt won't thread into it..

[Rick Whittridge]

Rob, I have a bolt if your interested, just send me a private message for details.

[ElJay]

If you'll send me your email address I'll send you the plans to make a puller device. This comes from the plan set of bensons and is intended for the mac 72/90. You will have to build it or have it built but is seems pretty straight forward and shouldn't take a good machinest but just a few minutes to make. Send to jctaylor90@yahoo.com
Its the one I'm going to make when I get to that point on my gyro....
ElJay